Important News! CoinLink has merged..... Visit our NEW Site www.CoinWeek.com

Category: US Type Coins

1793 Chain Cent – America Reverse

Photos used with permission and courtesy of Heritage Auction Galleries

Description:Chain Cents were struck only briefly in 1793, replaced by the more available Wreath Cent type, presumably due to contemporary criticism of the chain device. The March 18, 1793 edition of Philadelphia’s The Mail, or Claypoole’s Daily Advertiser stated the opinion, “The chain on the reverse is but a bad omen for liberty.”

Five die varieties of 1793 Chain Cents exist, and four of these share a common reverse die, which has AMERICA on the left border instead of the abbreviation of Sheldon-1, AMERI. Among the four AMERICA reverses.

Sheldon-2 is the rarest, aside from the non-collectible NC-1 variety. S-2 is promptly identified by its wide date, and LIBER is spaced much more closely than RTY.

Sheldon-3 is identified principally by the location of the 3 in the date, which is right aligned with the tip of the bust, and the location of the R in LIBERTY, which was entered high and tilted to the right. The variety, while scarce in all grades, can be obtained with patience in well worn and corroded condition, sometimes attributable only by the R in LIBERTY since the date may be faint or absent altogether. Sharp examples that retain their mint gloss are extremely rare, and in demand from both early copper specialists and determined type set collectors.

Sheldon- 4 is the final Chain cent marriage. Closely spaced LIBERTY with I and E high. The date is also close, particularly the 93. Both legends are followed by periods, a unique occurrence in the Large cent series. This was likely an affectation on the part of the die engraver, rather than a deliberate but ephemeral subtype.

Specifications:

Designer: attributed to Henry Voight
Mintage: 36,103 Less the 5-10,000 estimated Ameri. Variety
Denomintion: One Cent
Diameter: ±27 millimeters
Metal content: 100% Copper
Weight: ±208 grains (±13.5 grams)

Additional Resources :

Last Updated : 09/22/2007

1793 Chain Cent – Ameri. Reverse

Photos used with permission and courtesy of Heritage Auction Galleries

Description:

Considered the first Chain cent produced, and struck between February 27th and March 12th, 1793, the first coinage of the fledgling United States Mint after the facility was ready for operations.

Sheldon-1  The abbreviated legend on the reverse almost certainly represents a layout problem that resulted from the engraver’s inexperience. Presumably, the engraver laid out AMERICA last, and realized that the legend would appear unbalanced unless the nation’s name was abbreviated.

In his Encyclopedia of United States Large Cents, Walter Breen commented upon the belief of some who suggested that the abbreviated legend was “deliberate symbolism, after the style of the Masonic Unfinished Pyramid on the reverse of the Great Seal.”

The unique reverse legend identifies this variety as the first Cent issue struck at the first Philadelphia Mint. AMERICA is spelled out in full on the only other known Chain Cent reverse die, used to strike Sheldon-2, 3, 4, and NC-1.

Specifications:

Designer: attributed to Henry Voight
Mintage: Estimated between 5-10,000
Denomintion: One cent
Diameter: ±27 millimeters
Metal content: Copper – 100%
Weight: ±208 grains (±13.5 grams)

Additional Resources :

Last Updated : 09/22/2007

DISCLAIMER: All content within CoinLink is presented for informational purposes only, with no guarantee of accuracy.
CoinLink does not buy or sell coins or numismatic material, and has no ownership interest in any web site listed within CoinLink.
All News and Article links are direct, without framing, to the original source, which is solely responsible for the content.
No endorsement or affiliation to or from CoinLink is made.